#Smoothcursor only working sometimes pro#

Have a friend or family member press the button while you check the meter for a signal. To test the wiring between the chime box and the doorbell, disconnect the wires from the chime and hook them up to your volt meter. If the problem is damaged insulation on the wires, you can repair them with a little electrical tape. Do the same with the wires that are attached to the chime box.

Start by checking the two wires connected to the button-if they are frayed or loose, splice in a new section of wire and reattach to the button. It may have been exposed to water damaged by rodents or simply become bent, twisted, or frayed. Sometimes the wiring between the doorbell button and the chime box may be the problem.

#Smoothcursor only working sometimes pro#

You might want to call in a pro for this type of repair. Try changing the voltage range on the volt meter if the readings still don’t match, replace the transformer.

A low reading, however, might just need a second test. If the meter reading is higher, it indicates that the transformer is faulty and needs replacement. A properly functioning transformer will show a meter reading that matches the secondary voltage as marked on it. If no wires are loose, you should check the transformer using a volt meter: Connect the leads of the volt meter to the two terminals on the transformer. The wires may be marked “F” for front, “R” for rear, and “T” for transformer. Cut the power before you begin, then conduct a visual inspection to look for any loose connections or wires that are completely disconnected. The one exception is when you need to test the transformer, which is generally located in or near the chime box. Once you have found your replacement, simply hook up the two wires (which you have already disconnected from the original to test) and mount the new chime box on the wall-in some cases, you may need to replace the mounting brackets as well.įor most of these cases, you can troubleshoot a doorbell without shutting off the main power, because doorbells operate on very low voltage. The options on the market today are seemingly endless, with sounds ranging from simple tones to recognizable tunes. Often, the quicker, easier, and more cost-effective plan is to purchase a new chime box altogether. If no signal registers on the volt meter, it means there is a problem with the wiring to the box or the transformer (see below).Ī chime box is filled with electronic circuitry, so repairing one typically requires a skilled technician. Then have a handy assistant press the doorbell button: If the volt meter registers a signal, it means that the chime box is receiving electricity but is not working by sounding off. Take off the decorative cover, locate the two wires going to the unit, and attach the leads of a volt meter to each wire. To determine if the box is damaged, first remove it from its mounting bracket on the wall. If the pressing of the button isn’t the root of the problem, the malfunction might come from within the unit the unit that produces the sound or melody: the chime box inside the house.